|
作者: jilian [jilian] 论坛用户 | 登录 |
在网上查了下 都是SHOW RUN 出来的 谁能把配置过程写下来呀 interface Group-Async1 ip unnumbered FastEthernet0/0 ip access-group 101 in encapsulation ppp ip tcp header-compression passive async mode interactive peer default ip address pool dial ppp authentication pap group-range 33 40 ! ip local pool dial 10.1.3.1 10.1.3.254 ip classless ip route 0.0.0.0 0.0.0.0 10.1.100.182 ip http server ip pim bidir-enable ! access-list 101 permit ip 10.1.3.0 0.0.0.255 any dialer-list 1 protocol ip permit ! line con 0 line 33 40 modem InOut modem autoconfigure discovery transport input all autoselect ppp flowcontrol hardware line aux 0 line vty 0 4 login ! 在客户端拨号用的口令和密码在哪里配置呀 LINE 33 40里吗? 要不要用拨号组 |
地主 发表时间: 06-05-14 17:52 |
回复: rain_night [rain_night] 论坛用户 | 登录 |
看下CISCO的书就知道怎么写了,里面大多数命令在全局模式下配置的,部分在端口模式下配置. |
B1层 发表时间: 06-06-20 17:43 |
回复: jilian [jilian] 论坛用户 | 登录 |
问题找到了 不是配置问题 2610XM不支持NM-8AM V2模块 IOS不好找呀 |
B2层 发表时间: 06-07-11 17:15 |
回复: devil_tom [devil_tom] 论坛用户 | 登录 |
前不久做了一个NM16的,配置用户名和密码直接在全局模式下配置就OK了 |
B3层 发表时间: 06-07-13 10:28 |
回复: jilian [jilian] 论坛用户 | 登录 |
我的不行呀 模块没有问题 装上去之后就说线路没有硬件支持 换了个不带V2模块的的上去就好了 |
B4层 发表时间: 06-07-18 16:30 |
|
20CN网络安全小组版权所有
Copyright © 2000-2010 20CN Security Group. All Rights Reserved.
论坛程序编写:NetDemon
粤ICP备05087286号