论坛: 系统集成 标题: ~求助~~CCNA的两道题~老A要多帮我看看 复制本贴地址    
作者: tuzi [tuzi]    版主   登录
1 Bandwidth can be conserved by reducing the periodic distribution of Link State Packets (LSPs) so regular updates are exchanged only at some specified time interval.
Why is it passible to do this without causing the convergence time to increase dramatically?
A Sequence number can be used on LSPs
B Time stamps can be included in the LSPs
C Network topology changes trigger immediate LSP updates
D Each router's entire routing table can be passed to neighboring routers


2 When setting up RIP routing on a Cisco router.the network command contains no information about the subnets connected to the route ,only the class A,B,and C network addresses.Where does the router get this information?

A This information is not used. RIP updates for all subnets are sent to each subnet
B The touter "learns" which subnets are connected to each interface as the routing tables are populated
C If subnetting is used,the information must be entered for each router interface with the ip subnet command.
D The ip address command with IP addresses and subnet masks allows RIP to determine which subnets are connected to this router

3  What are the disadvantages fo connection-oriented network communications compared to connectionless service?(2个答案)
A Static-path selection
B Dynamic-path selection
C Data throughput is not guaranteed
D Static reservation of network resources
E Packert may arrive at their destination out of order

小弟英文是垃圾 看了半天没看懂什么意思 用了在线翻译 翻译的非常不准确
不知道上面这段话是什么意思 答案是什么 那位大哥帮忙解释一下 感激不敬~


[此贴被 带脚镣跳舞(tuzi) 在 04月14日18时13分 编辑过]

地主 发表时间: 04-04-14 17:58

回复: tuzi [tuzi]   版主   登录
楼上的 别瞎灌水~~~~~~

B1层 发表时间: 04-04-14 20:57

回复: rocky_20cn [rocky_20cn]   论坛用户   登录
B
D
BE

B2层 发表时间: 04-04-15 16:14

回复: tuzi [tuzi]   版主   登录
楼上的既然以后给出了答案  而小弟英语是在是垃圾 麻烦楼上的大哥能不能帮忙翻译一下


B3层 发表时间: 04-04-15 16:24

回复: Achieve [achieve]   版主   登录
表看,表看,偶就是表看

B4层 发表时间: 04-04-16 17:28

回复: tuzi [tuzi]   版主   登录
楼上的 吃错药了~
~表看  ????????????


B5层 发表时间: 04-04-16 17:59

回复: post228lb [post228lb]   版主   登录
找一个简单的先试译一下,偶的英文也不灵,不准确的地方欢迎再请校正。

2.当你在cisco路由器上设置RIP路由时,网络命令行不包括有关子网与路由连接的信息,而仅有A B C 类网络地址。路由器从哪里获得这个信息(子网与路由连接的信息)?
A。这个信息没有使用。RIP为所有的子网升级然后发送到每个子网。
B。和路由表的确立一样,路由器可以“学会”每个子网与路由器接口的情况。
C。。。。。。。。。。。。。
D.IP地址命令行和IP地址以及子网掩码允许RIP来确定哪个子网同该路由器相连。

B6层 发表时间: 04-04-17 00:08

回复: lqfrla [lqfrla]   论坛用户   登录
不是有这样的书吗

B7层 发表时间: 04-04-17 00:23

回复: Achieve [achieve]   版主   登录
那是xiean用我的帐号灌的水
我没什么时间仔细研究那几道题,再说你也不必被cisco限制了,他考自己的东西有时候你精通了,到了实际运用又不一定能用到它的东西,用到了,也用不到这个功能,这些问题只要原理懂了,看说明书就行了

B8层 发表时间: 04-04-17 09:16

回复: tuzi [tuzi]   版主   登录
谢谢老A指点
XIEAN个猪 拖出去卖了~~~~

B9层 发表时间: 04-04-17 09:22

回复: wbyq [wbyq]   论坛用户   登录
B
D
BE

B10层 发表时间: 04-04-17 15:42

论坛: 系统集成

20CN网络安全小组版权所有
Copyright © 2000-2010 20CN Security Group. All Rights Reserved.
论坛程序编写:NetDemon

粤ICP备05087286号